PDA

View Full Version : SOLD/CLOSED 12" Sundown Z v2



ThumpinTitan
02-11-2012, 10:59 PM
1. Product:
12" Sundown Zv2 SPL


2. Specs:
Nightshade Cone
Nightshade v1 Coil
Nightshade Spider (Single)
Dual 1 ohm


3. Description/Condition:
Few light scratches on Motor and Basket... Sub is in like new condition
Jacob recommends this sub for SPL use as the nightshade coil is very tight in the gap and can rub on music. Ive been runnin it daily off a Mojo 2k in a 1.75cu ft @ 34

I cannot guarantee it wont rub on you its worked pretty well for me. Was really only played to and from work (30 minutes each way) for about a month at not even half volume

Will be shipped in Original Sundown Box/Packaging.
4. Price:

$175 + Shipping

14" x 14" x 14" @ 57lbs from 92026

5. Pictures:

http://i286.photobucket.com/albums/ll98/SD_Titan/s1.jpg
http://i286.photobucket.com/albums/ll98/SD_Titan/s3.jpg
http://i286.photobucket.com/albums/ll98/SD_Titan/s5.jpg
http://i286.photobucket.com/albums/ll98/SD_Titan/s4.jpg














(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

southport2014
02-11-2012, 11:07 PM
so as of now there is no problems with it correct and whats the rms and what can it really handle pm me best priced shipped to 46237 thabks

ThumpinTitan
02-11-2012, 11:16 PM
Right now the sub plays exactly as i got it fro Jacob. Its played fine for me, but jacob says it may rub and strongly suggests this is an SPL sub

if you push down on the cone it doesnt rub, unless u push slightly sideways and down (im sure most subs rub if you do this anyways)


pm sent with shipping costs

SPLaudio
02-12-2012, 12:51 AM
the sub dose NOT have a nightshade coil. it is not possible and wouldnt fit the gap even with a hammer,lol....

ThumpinTitan
02-12-2012, 12:39 PM
the sub dose NOT have a nightshade coil. it is not possible and wouldnt fit the gap even with a hammer,lol....

Jacob himself told me it has a nightshade coil... you can ask him if youd like


Its a v1 coil... not the bigger v2 coils

SPLaudio
02-12-2012, 03:12 PM
sorry v1 or v2 nightshade coil dosent fit.

ThumpinTitan
02-12-2012, 03:19 PM
Alright well im not changing Specs until Jacob comes in and says otherwise

SPLaudio
02-12-2012, 05:55 PM
just dont want someone to buy and not get what they want or expect.

ThumpinTitan
02-12-2012, 11:36 PM
So peeps dont think im BSing lol

http://i734.photobucket.com/albums/ww344/ThumpinTitan/sundownjacob.jpg

ThumpinTitan
02-14-2012, 04:27 PM
Bump!!

Will trade for a nice monoblock

J31Rob
02-14-2012, 04:33 PM
lolpwnt

GLWS. Wouldn't mind burping this a couple times.

xmakeafistx
02-16-2012, 09:35 AM
anticipating sundownz reply.

nateberrier
02-16-2012, 10:00 AM
I had me a nice Z v2. Would take 3k easy probably. It now resides in florida :( Wish I had kept it.

sundownz
02-17-2012, 07:00 PM
This is one of the only ones we put an NS v.1 coil into -- ONLY the 50mm long NS v.1 coil fits this motor. It's incredibly tight.

NS v.2, Z v.3, NS v.1/2 SPL coils, etc, etc will NOT go in the gap at all.

ThumpinTitan
02-18-2012, 02:31 AM
There ya go, confirmed by the man himself... Thank you sir!