PDA

View Full Version : gap tolerance



dbjunior
12-13-2011, 12:54 PM
What is an acceptable tolerance for daily use? The coil. I want to use will have. 075 inside and. 072 outside. This is total difference between pole and coil Id and top plate and coil od so centered should be half that all the way around

dbjunior
12-13-2011, 02:37 PM
Bump

dbjunior
12-13-2011, 05:07 PM
Anyone. I know Spl subs run a tighter gap than daily but what is the cutoff?

dbjunior
12-13-2011, 08:19 PM
Should I ask on a different forum

06goat
12-13-2011, 08:30 PM
Im gonna need the measurement down to 50 millionths for proper calculation

CHEMMINS
12-13-2011, 08:35 PM
Ask at DIYMA.

wenn_du_weinst
12-13-2011, 08:58 PM
I've ran a sub with tighter tolerances then that daily no problems

dbjunior
12-14-2011, 06:44 PM
I've ran a sub with tighter tolerances then that daily no problems

Thank you this was helpful. Time to buy coils.

wenn_du_weinst
12-14-2011, 06:46 PM
mine were at .06"