PDA

View Full Version : Using midrange speaker from component setup ok for rear????



08Accord
11-29-2011, 07:39 PM
So I have the JL TR series component setup but I'm not exactly pleased with it. As of now i need to replace my rear coaxials cause they are blown (i know people say just go front stage, but with this i disagree). So with that being said, is it ok to use the midrange of the JL components and buy gooooood components?

Why So Cereal?
11-29-2011, 08:43 PM
yupp. just be sure to bandpass them

keep_hope_alive
11-30-2011, 07:06 PM
bandpass needs depend on the speaker. some woofers have a natural high frequency roll-off, other have a lot of break-up and response variations at high frequencies. the inductance of the voice coil will provide roll-off anyway.

if you want to be safe - a 6 dB/oct low pass filter (passive) centered at 3-4kHz would be fine.

a high pass filter depends on the woofer used and the rear speaker location.

zako
11-30-2011, 11:27 PM
The bandpass shouldn't be difficult to implement and it won't hurt even if speaker can roll off naturally. For the low pass filter, you can put an appropriate inductor inline, creating a 1st order low pass filter at a desired frequency.