View Full Version : False floor designed, couple questions tho...

11-07-2011, 09:36 PM
I have designed my false floor, more or less. The design may change slightly but it's pretty much as seen in the pictures. I am going to do it in two pieces the bottom and sides as one piece and the top as a separate piece. It will be 31" x 41" with two sides closed off for support and the other two open to let air move through to vent the amps. There will also be a support in the center with a opening to allow wires through. On the left hand side toward my rear hatch will be a 12 x 7 cutout for my battery.

My main question is, how would I attach the top. I don't want to screw it down because I want to be able to easily get into the amps and make adjustments.

Also, is there enough support or should I add a little to the open sides?

Any other suggestions?

Excuse the pics, I am not great with sketch-up but it works.









Bumpin' Goalie
11-07-2011, 09:46 PM
As far as securing the top, velcro and/or hinges are easy enough. With velcro lining the perimeter, good luck having it move without intention.

11-07-2011, 10:13 PM
Will hinges cause vibrations and will velcro be strong enough to hold it?

11-07-2011, 10:19 PM
Will hinges cause vibrations and will velcro be strong enough to hold it?

good Velcro's pretty **** strong, it has pulled the carpet right off the floor of my car before.

11-07-2011, 10:22 PM
Ive done hinges and with no vibrations at all

11-07-2011, 10:25 PM
i got hinges no problems

11-07-2011, 10:31 PM
Are they hidden/invisible?