View Full Version : Mmats m3000.1d

09-06-2011, 10:45 PM
Item(s) for Sale:I have a barely used M3000.1D
My amp is 10/10 in fuctionality and 10/10 cosmetically with acception to the mounting feet having been used. other than that this amp is mint and in the box. im LOOKING FOR $700 IN MY POCKET, SHIPPING IS ON YOU. LET ME KNOW IF YOU HAVE OFFERS.



09-07-2011, 12:52 PM

09-08-2011, 06:45 AM
bump for those of you who know what this bad boy can do...

09-28-2011, 12:30 AM
Bump for reasonable offers! I'm flexible!

09-28-2011, 01:58 AM
I cant believe you still have this thing.

09-28-2011, 02:25 AM
I cant believe you still have this thing.

I can...

09-28-2011, 09:44 AM
Tell me about it. I thought I'd have this beast sold by now. I guess people want something for nothing nowadays.

09-29-2011, 01:41 AM
How firm are you on that price?

09-29-2011, 07:00 AM
I can be flexible ifyour ready to pay. Pm me an offer

09-29-2011, 10:24 AM
Free bump for a great power house of an amp, I have one (but the .5) on a DC level 5 18 D1 and it's LOUD and low lol. For the power really a small footprint, oh yea clean power too.

09-30-2011, 06:12 AM
Thanks! Very true. As efficient as they get. Gobs of power. You guys got any offers? I want cash but il take an I pad n some cash!!

10-21-2011, 09:33 PM
Ok let's do this $500 shipped!!!

10-21-2011, 11:05 PM
Good price. i'd buy it if I didn't have my 3500.1 already.

10-22-2011, 12:09 AM
Yea, I'm looking to sell this puppy, so priced to sell and ready to ship!

10-22-2011, 12:35 AM
What are the dimensions? L and W mostly

10-22-2011, 12:56 AM
Str8 from the MMATS site

*********************************************** M3000.05D** M3000.1D
STABLE TO:*********************************** ohm************ 1 ohm
@ 13.8 Volts:
Watts @ .5 ohms mono*********** 1 X 3000********** N/A
Watts @ 1 ohms mono************ 1 X 1700********** 1 X 3000**********************
Watts @ 2 ohms mono************ 1 X 850 *********** 1 X 1700**********
Idle Current:**************************** 1.5 amp*********** 1.5 amp***********
Signal to Noise Ratio A-Wtd:*** <85dB************* <85dB*************
Total Harmonic Distortion:****** 0.3%**************** 0.3%****************
Channel Separation:**************** N/A****************** N/A******************************
Input Sensitivity:********************* 150mV-2.5V***** 150mV-2.5V******
Slew Rate: ****************************** 13V / Usec******* 13V / Usec******
Fuse Rating / Dual:****************** 100 amp********** 100 amp**********************
Height:************************ 2.25”*************** 2.25”***************
*********** Width:************************* 9.5”***************** 9.5”*****************
*********** Length:*********************** 13”****************** 13”******************
General Information:
Frequency Response: ************* <10Hz to 275Hz
Low-pass Filter:************ Variable 24db, 77 to 275Hz
Battery Connectors:***************** 2 Gauge
Speaker Connectors:*************** 8 Gauge
Main Power Wire: This is the wire that runs from the front battery to the rear distribution block in the trunk. Always use a 1/0 gauge minimum.
(2) Positive Power Terminals –This is the power feed from the distribution block in the trunk. Use 4-gauge cable (MINIMUM) and good quality terminals when routing this connection. Tighten all connections well to prevent power loss due to bad contact. Route the power cable away from the RCA jacks and speaker cables.* You MUST use BOTH positive and negative connectors.
(2) Ground Terminals - For optimum performance, use 4-gauge cable MINIMUM! Connect these cables to a secure area of the body in the trunk. You MUST use BOTH positive and negative connectors.* *See note below.
Remote Terminal - The amplifier will turn on when 12 volts is applied to this terminal. This 12-volt signal is usually taken from the Power Antenna or Remote wire coming from the source unit.
Speaker Terminals - Connect to speakers using 14-gauge wire (minimum). Running too low of a speaker impedance will cause the amplifier to go into a fault condition.
Crossover Filter – Linkwitz/Riley 24db slope. This control sets the 6db down point of your amplifier.
Gain – Allows input levels between 150mV (max gain) and 2.5 volts (min gain) for full output.
Recommended Fuse – Dual 100 amperes.
Protection: Due to the high-current demands of the D3500’s, they are designed with a very fast low-voltage shutdown circuit. If you should experience a solid protect light, simply shut the system off and power it back up. If this condition persists after continued playing, it is a sure sign that you Do Not have enough battery supply or alternator charging or both. The philosophy “If some is good, more is better”, surely applies here!
Recommended Battery: You should use 1 battery for each amplifier. If your system uses only 1 amplifier, then the starter battery should be sufficient. The starter battery should always be upgraded with a high output audio battery. Note: When you have to parallel 2 or more batteries together always use the same, size, brand and amperage of battery. This will ensure that the batteries charge equally. We do not recommend battery isolators. At 2 or more batteries, you will need to upgrade your alternator.
Note: If you use the chassis as a source for your ground in the trunk, you MUST increase the size of the wire that runs from the front battery to the fender. Remember; 12 volts has to run in a continuous loop and if you do not increase the ground wire up front the voltage/current will be restricted and your system will not play to its fullest.

10-22-2011, 06:47 PM

10-22-2011, 07:35 PM
Are you in any way interested in the mmats 2100.2? I think I need to sell/trade my amp before I can justify buying a bigger one.

10-22-2011, 08:17 PM
Na I need the cash man.

10-22-2011, 08:36 PM
Thats much more like it, very good price now for an incredible amp. If I had the expenses and power to run it I would for sure pick it up.
GLWS. May wanna try eBay if no bites.

10-22-2011, 11:26 PM
Yea had a guy buy it off of eBay two weeks ago and he stiffed me on the payment. This thing doesn't even need much power behind it really. It's a power plant. Hoping to see it sell at this price.

10-24-2011, 11:16 PM
Nightly bump.

11-01-2011, 01:02 AM
trade for 2 dc level 4 18s?