PDA

View Full Version : FS: Polk/momo Carbon C300.2 2-channel amp



Vital
08-22-2011, 12:22 PM
Item(s) for Sale:

POLK Audio/MOMO C300.2

Item(s) Description/Condition:

Brand new, only taken out of plastic to drool over and then today to take these pics. Comes with everything they come with - manual, warranty card, sticker certificate......

See wattage certificate below, amp does more then rated (just like every Polk/Momo amp does)

150 watts RMS x 2 at 4 ohms
220 watts RMS x 2 at 2 ohms
550 watts RMS x 1 bridged output at 4 ohms
stereo or bridged mono output
4-ohm stable in bridged mode
Tri-way capable (Tri-Way crossover required)
Maximum Dynamic Headroom (MDH) power supply
requires 4-gauge power and ground leads
variable high- and low-pass crossovers, 50-250 Hz, 18 dB/octave
subsonic filter at 15 Hz, 24 dB/octave (only operates with low-pass filter activated)
6-way Smart System Protection circuitry guards against power and ground reversal, overheating and shorts, current overdraw, and low impedance
Pre-EQ switch optimizes the crossover and bass level especially for use with Polk/MOMO full-range speakers and subwoofers
RCA inputs accept both speaker- and preamp-level input (To use the inputs as speaker-level, you must attach RCA connectors to your speaker wire.)
preamp outputs
optional remote subwoofer level control
dimensions: 13-3/8"W x 2-9/16"H x 9-3/4"D

C300.2 features a Pre-EQ switch, which optimizes the crossover and bass level especially for use with Polk/MOMO full-range speakers and subwoofers!


Price:

$200 shipped

Shipping and Miscellaneous Item Information:




Item Pictures:
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)).

Don't have itrader feedbacks on CA but have them on diyma, caco and nissanclub all under the same name - Vital

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1565.jpg

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1566.jpg

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1567.jpg

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1568.jpg

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1569.jpg

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1570.jpg

http://i37.photobucket.com/albums/e52/vitalpics/DSC_1571.jpg

Dirtrider4eva
08-22-2011, 12:51 PM
pretty sharp amp there. never had any polk, but looks nifty

Sunfire01
08-22-2011, 03:30 PM
**** amp bro GLWS, i wish i had 200 id buy this right now!

Vital
08-22-2011, 03:39 PM
^^^ Looking at your sig i see you're already familiar with Polk/Momo.
I had 6.5'' components for some time - these things were LOADED with bass while still sounding nice and clean everywhere else on frequency spectrum. Later on replaced them with Polk SR series.

1blualti
08-25-2011, 07:43 PM
would this amp be enough to run an 12" sr svc...believe the sr handles 700rms @4 ohm...i had talked to you awhile back when i had the barris 900.6 but had to sell due to money issues...now just looking for an amp to push the sr

Vital
08-25-2011, 10:51 PM
SR svc subs are 700 rms at 4ohms.

This amp is rated for 550 rms and since it's underrated as certificate shows i bet i'll realistically do 600 rms at 4ohms.

So yes, this amp will work for svc SR sub just fine.

1blualti
08-25-2011, 11:23 PM
thats what i was figuring...i may pick this up from you if i can't work out a deal w/ a guy for a arc ks300.2 which will do the 700rms @ 4ohms...so ill get back to you soon...thanks

Vital
08-31-2011, 03:23 PM
bump

Vital
09-06-2011, 12:41 PM
Offers?

Vital
09-12-2011, 01:26 PM
bump