View Full Version : JL 450.4 v1

06-29-2011, 06:14 PM
Item(s) for Sale: JL 450.4 v1

Item(s) Description/Condition: Item is in like new condition with very minor cosmetic blemishes. The amp was only used for about a month and then I sold the car it was in and I've had it sitting in my closet for a couple years now.

Price: $250 shipped obo

Shipping and Miscellaneous Item Information:

Item Pictures:
(List pictures in this section, 1st picture should be your username/date if you have less than 10 positive feedbacks with the i-Trader system or less than 10 references that you have sold to in the past. (These must be listed in your signature, or a link provided to a feedback thread listing these references)). http://img.photobucket.com/albums/v680/glowin3232/DSC_1098.jpg

These next 2 pictures are to show the only cosmetic blemished on the aluminum face of the amp, they are very small...

06-29-2011, 07:40 PM
pioneer double din for it? i have one already and i need another

06-29-2011, 08:15 PM
I'm really looking for cash, thanks for the offer though.

07-01-2011, 05:48 AM

07-01-2011, 06:49 AM
my offer still stands man

07-01-2011, 12:57 PM
What kind of Pioneer do you have?

07-03-2011, 12:48 AM

07-03-2011, 09:16 PM
Price drop to $250 shipped, NEED THIS GONE!!!

07-04-2011, 04:14 PM
pm me rock bottom price shipped to 95023 if I paypal you right now, I am just a little short and want to see if I can get this sold for you.

07-06-2011, 10:55 AM
What kind of Pioneer do you have?

basically brand new pioneer avhp4200

07-06-2011, 11:35 AM
cant remember, but could that amp do bandpass on channels 3 and 4? if so, I might step up from my 300/4

07-06-2011, 02:45 PM
Copied from JL's website, hope this helps...

4-channel car amplifier
150 watts RMS x 2 and 75 watts RMS x 2 at 1.5 to 4 ohms
300 watts RMS x 1 and 150 watts RMS x 1 at 3 to 8 ohms
Regulated, Intelligent Power Supply system
differential-balanced inputs
variable high-, low-, and band-pass filters (high-pass only on ch. 3 and 4)(50-5000 Hz, 12 or 24 dB/octave)
switchable bass boost (ch.1 and 2 only) (6 dB at 48 Hz)
infrasonic filter (ch.1 and 2 only) (24 dB/octave at 30 Hz)
optional wired remote bass boost (ch.1 and 2 only)
Absolute Symmetry™ Class-AB amplifier design
MOSFET power and output stages
speaker- and preamp-level inputs (speaker-level input requires an optional adapter)
preamp outputs
4-gauge power and ground leads and a 60-amp fuse recommended — wiring and hardware not included with amplifier
no onboard fuses — when installing multiple amps in a system, an additional 60-amp in-line fuse between the distribution block and the amplifier is recommended
19-11/16"W x 2-5/16"H x 10-1/16"D

power subwoofers from channels 1 and 2, which have bass boost and low-pass filters available, and drive your front speakers with channels 3 and 4 in high-pass mode;
drive your front speakers with channels 1 and 2, your rear speakers with channels 3 and 4, and use the preamp outputs to connect a separate amplifier to drive a subwoofer system;
power your midbass speakers with channels 1 and 2, and your midrange/tweeter combo with channels 3 and 4;
power left, center, and right speaker systems with channels 1 and 2, and channels 3 and 4 bridged.

07-06-2011, 03:08 PM
Wish I had the cash for this one. Very clean amp here folks, and lots of power. S/N ratio is outstanding. GLWS

Why So Cereal?
07-09-2011, 02:32 PM
I want it!!! darn u empty wallet!!!

07-11-2011, 11:20 PM

07-15-2011, 04:45 AM
Bump it up.

07-16-2011, 01:23 PM
For some reason I cannot edit my original post... FINAL PRICE DROP to $225 shipped!!! Somebody snag this!

07-17-2011, 02:29 AM
i want it, just bid on one on ebay, high bidder, if i get outbid, and this is still available, i buy it, paypal asap, ship to Tampa

07-18-2011, 05:30 AM
sounds good

07-18-2011, 05:40 AM
So if I am reading this right thats staggered power only? like you can't make it a matching power 2channel?

07-18-2011, 12:18 PM
You are correct :)

07-18-2011, 08:10 PM
Payment sent.

07-19-2011, 12:22 AM