PDA

View Full Version : Alpine CDA-9887 and crossovers



jaysexxin
06-14-2011, 01:00 PM
Good morning,

The alpine has dip switch on the chassis for 2 xover settings; 2way and 3way. What is the best way to setup the deck with the equipment I have? Can I even do 3 way?

Here is my setup for the speakers. I only have 1 set of speakers (i only have room for 1 set)

Viper 550.2 components (100 RMS) - powered by MRP-F240

MRP-F240
40 watts RMS x 4 at 4 ohms
50 watts RMS x 4 at 2 ohms
100 watts RMS x 2 bridged output at 4 ohms

I was going to bridge and have the set run at 100 watts.


Thanks in advance

Buck
06-14-2011, 01:02 PM
I have mine on 2 way. Unless you are going SQ I don't see why you would have it on 3 way.

jaysexxin
06-14-2011, 01:19 PM
Thanks for the response. The reason I was thinking about 3 way was because I wanted to be able to control the mids and the the tweeters individually with my deck.

The 2-way setting only allows me to change the crossovers for the components as a whole but the 3-way gives options for both mids and tweeters. The more I think about it, it doesn't matter since the tweeters are using the components crossover HPF... right? :confused:

Buck
06-14-2011, 01:20 PM
3 way would be if you are going active, I believe.

jaysexxin
06-14-2011, 01:22 PM
What do you recommend for the equipment I have? 2 way?

Buck
06-14-2011, 01:24 PM
What do you recommend for the equipment I have? 2 way?

Yep. 2 way + sub. I don't think you would gain anything by doing 3 way, but I could be wrong.

jaysexxin
06-14-2011, 01:30 PM
Thanks for your input!

Anyone else?