PDA

View Full Version : Please Help



trigger2008
02-13-2004, 09:48 PM
I just recieved my component set of mb quart and the X-overs have a high input and a low input. Do I have to use two different amps for this or can I just run a full range amp into the low input or high input or both. I am looking for the tweeter sound more than anything. These will be going in my dash I already have Kappa,s in the doors.

zephyr
02-13-2004, 10:38 PM
sounds like a bi-amp inputs. there should be a switch or jumper to configure whether the crossover is bi-amped or not. then you can hook up the speaker wire to either one of the inputs.