PDA

View Full Version : Help, Diagnose this two way remote problem with viper 5701



bigdano
04-08-2011, 05:22 PM
Hey all

Whenever I press the unlock button on my two way remote, the truck chips twice like normal, then two to three seconds later the truck emits an additional chirp and my two way remote beeps a high and then low tone repeatedly for like ten seconds.

There has got to be a known solution on this.

Dan

Tone415
04-08-2011, 05:24 PM
Read manual... Bring back to installer..

bigdano
04-08-2011, 05:29 PM
I'm the installer. I tried to read manual but didn't see anything describing the above.

bigdano
04-08-2011, 05:53 PM
Low transmitter battery could be the problem, however I JUST replaced the transmitter batteries 5 minutes ago, and I am not sure if the remote beeping twice repeatedly is the indication of low battery.

mendon99
04-09-2011, 01:15 PM
does it do it with both remotes? odd issue.. if the manual says nothing I'd call DEI tech they'll know

bigdano
04-09-2011, 04:14 PM
I think I figured the problem out. The remote is a piece of ****. The brass holder that holds both batteries in place was pulled back a bit from getting old batteries out. This caused a bad connection with the batteries in the remote. I bent the brass down some, so it would exert more downward force on the batteries holding them in the remote further.

I think this solved the problem.

SoundConnection
04-27-2011, 05:53 PM
If it continues to happen pm me.