Jason19

02-21-2011, 10:59 AM

I have a nice hifonics colossus amp that im looking to trade for a smaller amp im looking for around the same power or can be less but with a smaller heatsink this amp is just way to **** big its about 35 inches long anyways the amp is not perfect has a few scratches nothing bad aslo does not have the mounting feet but some could be made very easy here are the specs on the amp.

600W x 2 @ 4 Ohms

1100W x 2 @ 2 Ohms

1600W x 2 @ 1 Ohm

2000W x 1 @ 4 Ohms

3200W x 1 @ 2 Ohms

Slow Un-Mute Turn-On

Frequency Response: 2Hz - 250Hz

Dampening Factor: 400

S/N Ratio : 98dB

THD & N: 0.10%

Variable Input Level Control: 0.2V-9V

Input Level Control: 0.04V-18V

Variable Input Impedance: 0.6k - 47Kohm

Input Impedance: 20Kohm

Power/Diagnostic L.E.D.

DC, speaker short, thermal, overload

Power Supply MOSFET

Audio Output MOSFET

Variable Low Pass Filter/24dB - 35Hz-250Hz

Variable Subsonic Filter - 10Hz-50Hz

Variable Bass EQ - 0-18dB between 30Hz - 60Hz

Phase Shift (0-180 degrees)

Unbalanced Inputs (RCA)

Balanced Inputs (DIN)

Line Output ( RCA) - High Pass

Speaker Terminals - 10 ga.

Power/Ground Terminals - 2 ga. x 2

Remote Bass Module WBR-1 (Rj11)

Dimensions (LxHxW): 11.28 " x 2.68" x 40.52 "

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1185.jpg

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1186.jpg

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1187.jpg

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1184.jpg

600W x 2 @ 4 Ohms

1100W x 2 @ 2 Ohms

1600W x 2 @ 1 Ohm

2000W x 1 @ 4 Ohms

3200W x 1 @ 2 Ohms

Slow Un-Mute Turn-On

Frequency Response: 2Hz - 250Hz

Dampening Factor: 400

S/N Ratio : 98dB

THD & N: 0.10%

Variable Input Level Control: 0.2V-9V

Input Level Control: 0.04V-18V

Variable Input Impedance: 0.6k - 47Kohm

Input Impedance: 20Kohm

Power/Diagnostic L.E.D.

DC, speaker short, thermal, overload

Power Supply MOSFET

Audio Output MOSFET

Variable Low Pass Filter/24dB - 35Hz-250Hz

Variable Subsonic Filter - 10Hz-50Hz

Variable Bass EQ - 0-18dB between 30Hz - 60Hz

Phase Shift (0-180 degrees)

Unbalanced Inputs (RCA)

Balanced Inputs (DIN)

Line Output ( RCA) - High Pass

Speaker Terminals - 10 ga.

Power/Ground Terminals - 2 ga. x 2

Remote Bass Module WBR-1 (Rj11)

Dimensions (LxHxW): 11.28 " x 2.68" x 40.52 "

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1185.jpg

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1186.jpg

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1187.jpg

http://i224.photobucket.com/albums/dd219/Jasoninwisconsin/amps/100_1184.jpg