PDA

View Full Version : molex plug question



collin.k
02-20-2011, 10:28 PM
so i just wired up my front door speakers and had to drill out either side of the molex and slide the wire on through. no big deal but i got to the back doors and realized its a much smaller plug and cant drill that one out at all so how would you guys go about wiring up rear speakers without drilling the plugs?

dbjunior
02-20-2011, 10:41 PM
cut and solder or if you have wire solder and heatshrink

collin.k
02-21-2011, 01:00 PM
what, just figure out which ones are speaker wires and splice into them with the amplified wire?

gunz4me2
02-21-2011, 01:31 PM
When I do the door speakers in my wife's car, I am thinking about adding 2 more pins to the molex. Use the existing stock wire for the tweeter then run wire and re-pin for the woofer. I'm not opposed to using existing factory wire because no matter what anyone tells you, you won't hear a difference for using a smaller gauge wire for a couple of feet. If one's amp can't overcome a few feet of smaller gauge factory wire, then that amp is a POS!