Securing kickpanels

[Scorpion]

Here is a newbie question for yall: Once I have constructed a kickpanel out of fiberglass, how do I secure the new panel to the pick-up??? New kick will house one of two RMB8's.


I have:
1983 Ranger Reg Cab
Optima Blue Cap
1.50 Farat Cap
Kickers: RMB6 (Tweet), RMB8 (Mid), Comp VR 10" (Sub)
Amps: Jensen 4ch 600w, Profile CL800
Pioneer MP3 Head Unit
Legacy 12 Band Eq

[Bill T.]

Drywall screws?

Bill T.

[TPABlazer]

superglue?

[ParkRat]

DucTape? Maybe a dow rod?

[Scorpion]

First: Dry wall screws?? Will they go through 20 ga steel plate?

Second: Superglue?? I would like to be able to remove if damaged in any way.

Third: Duct Tape?? Hey man I am not McQuyver.

Thanks for the suggestions, I will concider them. A friend suggested that when I build the kick to find the original mounting points and design them into my kick.

What do you think?

[Bill T.]

Drywall screws will go through just fine. If at anytime it dont, pre-drill with a 1/8" bit.

Bill T.

[ParkRat]

First: Dry wall screws?? Will they go through 20 ga steel plate?

Second: Superglue?? I would like to be able to remove if damaged in any way.

Third: Duct Tape?? Hey man I am not McQuyver.

Thanks for the suggestions, I will concider them. A friend suggested that when I build the kick to find the original mounting points and design them into my kick.

What do you think?

Who is McQuyver? I was just kidding about the duct tape and dow rods. :D

[Scorpion]

Kind of figured you were ParkRat. Just struck me funny. LMAO

[jbl_marshall21]

velcro.....

[forbidden]

Screws or 3M body tape.