PDA

View Full Version : What to use?



bmoney9
06-28-2010, 02:41 AM
I need to cut the speaker hole in the mdf board and not sure how to do it. This is my first box build. I do love it but anyways, I do not have a router and I am wondering if there is a way without going out to buy one. Any other options?

hatedonmostly
06-28-2010, 02:42 AM
jigsaw

RidinSwangaz
06-28-2010, 02:43 AM
Jigsaw is easy to use also.

bmoney9
06-28-2010, 02:48 AM
ok..any type of blade necessary?

also, I use titebond for glue? (or What do you recommend using?)

and liquid nails for the seams? Correct?

hatedonmostly
06-28-2010, 03:02 AM
ok..any type of blade necessary?

also, I use titebond for glue? (or What do you recommend using?)

and liquid nails for the seams? Correct?

i don't believe so

yes

never used it myself, just used caulk. but can't hurt.

bmoney9
06-28-2010, 03:30 AM
alrighty..thank yoU! will continue my box build tomorrow if its not too hot..mayb ill just work in the garage

hatedonmostly
06-28-2010, 03:34 AM
Good luck man, pics and vids when done are a must :)

on1wheel01
06-28-2010, 03:54 PM
Jig saw will work just go slow. Also tite bond 2 for glue, and I use painters caulk from lowes like 2.50 a tube

bhsdriller
06-28-2010, 03:56 PM
ok..any type of blade necessary?

also, I use titebond for glue? (or What do you recommend using?)

and liquid nails for the seams? Correct?

a blade that is made for wood, all I had was a metal cutting blade and it didn't do ****

quins90lac
06-28-2010, 08:39 PM
paneling blade will give you a nice smooth cut.

Louisiana_CRX
06-28-2010, 08:41 PM
be sure to take pics

on1wheel01
06-28-2010, 09:18 PM
One tip is get a piece of wood get the radius drill one screw the middle in then put a screw on the outer so it is protruding just a bit to scrape the box, scrape it around a few times. It will give you a channel for the jig saw to go in and will help you stay in the circle. I did that before I had my circle jig. That's about the best advice I can give u.