PDA

View Full Version : Box build for Brandon



Mike465
04-13-2010, 08:50 AM
Ok everyone this box is for Brandon's two DC Audio Level 3 12's.



Box is 3.0 cubic feet with 43 square inches of port tuned to 32Hz.





http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00167.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00169.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00170.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00171.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00172.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00173.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00174.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00175.jpg

BigSix
04-13-2010, 11:25 AM
bad *** work as usual bro.....

302yota
04-13-2010, 11:30 AM
x2.....all of your boxes seem to amaze me, but it's ok, i'll be that good one day....lmao

Mike465
04-13-2010, 02:56 PM
http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00176.jpg



http://i701.photobucket.com/albums/ww12/AmiCreation/DC%20Audio%20Level%203%20Dual%2012%20Box%202/DSC00177.jpg

302yota
04-13-2010, 09:17 PM
nice....how did you make the seam look so nice along the port edge? the only way i can do that is by cutting grooves to tuck the carpet in...is that what you did?

Blasphemy
04-13-2010, 09:20 PM
You got some skillz.

Mike465
04-14-2010, 07:49 AM
nice....how did you make the seam look so nice along the port edge? the only way i can do that is by cutting grooves to tuck the carpet in...is that what you did?

Very simple, just take you knife ( With a fresh razor blade) cut iinto the area where your port is and run the blade along the edge of the port. You will use the port as an edge guide and this will give you a nice clean edge.