PDA

View Full Version : what to drill out terminal cups with?



KBCnick
04-02-2010, 08:17 PM
so what do you guys use to drill out the hole for your cups? is it possible to use a jig saw?

bubbagumper6
04-02-2010, 08:18 PM
Well if they're small enough you can use a hole saw kit. Those usually go up to like 2". Or a router...

KBCnick
04-02-2010, 08:21 PM
alrighty.

bubbagumper6
04-02-2010, 08:22 PM
alrighty.

You can get a cheap hole saw kit at Harbor Freight for like 5$ provided your terminal cups are both round and not huge.

KBCnick
04-02-2010, 08:24 PM
yeah theyre like 2 inch round. should work.

bubbagumper6
04-02-2010, 08:26 PM
Yeah just remember when your trying to drill it out that your probably going to have to go in from both sides. The first time I used mine it got like 1/2 way in and just stopped and I couldn't figure out why, it was because my hole saws were only like 1/2" deep, and of course it was 3/4" wood...so yeah, just go as far as you can one way, then drill the rest from the inside.