PDA

View Full Version : can i bend round ports with 90 degree elbows? PVC?



stanky1219
03-02-2010, 01:10 AM
i have a box with 2 cvr's in it now.

i built it 2.2cu ft per sub. 4 inch ports tuned to 35hz.

i want to put jl 13w3's in it sometime down the road but jl recommends tuning to 27hz.

i dont have that much depth though. can i bend with round ports?

Louisiana_CRX
03-02-2010, 01:12 AM
that dog will hunt........

stanky1219
03-02-2010, 01:14 AM
huh? lol

cx-7heaven
03-02-2010, 01:17 AM
yes you can, make sure to calculate the lenth of the bend into your tuning. The way I do that is to use a measuring tape, measure the shortest part of the bend( inside), then the longeest part ( outside), add them together, and divide by 2.

stanky1219
03-02-2010, 01:22 AM
it is not letting me post? if this shows up thanks cx-7

cx-7heaven
03-02-2010, 01:25 AM
np