PDA

View Full Version : Questions on painting inside of port



justafifteen
02-10-2010, 06:36 PM
How do I paint the inside of my port if it's only 4" wide? I don't have the top of my box glued on yet while I find out how to do this.

I sealed my box with liquid nails, and I want to do the same with the top after it's glued onto the box. So I can only paint it after the top is glued on and sealed... but I don't have much room to move a can of spraypaint around inside the port. Can anybody give me some advice?

Slo_Ride
02-10-2010, 06:41 PM
use a roller, shoulda painted it before hand but... :)

302yota
02-10-2010, 06:53 PM
i normally paint my port during the assembling of all the pieces.....but you can prolly just take a spray can and spray into the port until most of it is covered, i know it wont be a nice and even coating...but its hard to see inperfections once it's all together

TnT_Sounds
02-10-2010, 08:28 PM
should've painted before you put it together

make sure you lay down a good primer sealer or it will take quite a few coats

justafifteen
02-10-2010, 10:36 PM
Thanks for the advice guys

If I had painted it before I put it together, how would I seal the port with anything without it showing?

TMali
02-10-2010, 10:39 PM
just use some rattle cans and spray some paint in there

on1wheel01
02-12-2010, 08:27 AM
i use a roller

bubbagumper6
02-12-2010, 08:29 AM
Just spray paint it dude, I've done it for 2 of my previous builds and they both turned out fine.

Villeza1
02-12-2010, 08:47 AM
Spray paint