PDA

View Full Version : Need Design for 4 12" Type R's Will Pay $$



eskimochaos
12-26-2009, 10:58 PM
Hey guys, I need a box design for 4 12" Type R's. They are going in a 2007 4Runner and are going to be powered by a AQ2200D at 1ohm.

Looking for a ported box design with cut list. Ideally EXTERIOR dimensions are 40" width, 21" depth and 23" height, I can really only change the depth dimension as the wheel wells are about 40" wide in the trunk and I do not want the box to be higher than the seat backs for safety and visibility reasons.

I dunno what to tune or port to so I'll leave that up to you. I will PayPal you $10, ideally I need them this weekend as I'd like to start this week.

EDIT: For design purposes, I suppose we can extend the box over the wheel wells: here is what my 4Runner trunk looks like currently.

http://img369.imageshack.us/img369/6500/img0634er4.jpg (http://imageshack.us)
http://img369.imageshack.us/img369/6500/img0634er4.e1f5c73e10.jpg (http://g.imageshack.us/g.php?h=369&i=img0634er4.jpg)

marcotheclepto
12-27-2009, 12:01 AM
would be better if you can go higher, as it is its impossible to fit all 4 on one side. also the added volume would be a bonus.

thegreatestpenn
12-27-2009, 12:04 AM
all 4 will fit on the top in a V or staggered, then shoot the port back.

SPLluminator
12-27-2009, 12:04 AM
I could possibly do a design. Pm me.

marcotheclepto
12-27-2009, 12:05 AM
all 4 will fit on the top in a V or staggered, then shoot the port back.

hmm yeah. i almost edited it and put unless angled. lol

Bumpin' Goalie
12-27-2009, 12:05 AM
sub up port back for sure. probably stagger them to fit space requirements.

marcotheclepto
12-27-2009, 12:06 AM
if depth can go to 23 i can do 8 cubes @ 32.

dappa5
12-27-2009, 12:09 AM
well i see some heavy hitters in here but if you still need pm me i'll fix you up

eskimochaos
12-27-2009, 12:19 AM
Hey guys, thanks a lot.

Ill let you all know tomorrow what my exact final exterior dimensions can be. It was raining outside tonight and did 2 second measurements. We might be able to squeeze 42" width and possibly and inch or so in height.

Thanks again,

Ill let you know tomorrow.

Cheers!

thegreatestpenn
12-27-2009, 12:23 AM
I could possibly do a design. Pm me.

your FS thread cursed mwca. as soon as it was put back up the server went down :crying:

dappa5
12-27-2009, 12:25 AM
lol

eskimochaos
12-27-2009, 12:26 AM
Sorry double ppst, I'm loosing internet connection. Fml

SPL Blazer
12-27-2009, 12:34 AM
One of our competitors was running four 12" Type R's last season. He also happens to be a professional enclosure designer and builder, I'm sure he could give you a design to work with. Check out his thread on here, http://www.caraudio.com/forum/showthread.php?t=415993