View Full Version : NEED design for T5 10s
12-04-2009, 01:48 PM
i have all dims of the box but need a new top plate and port design. Need this ASAP. Pm me
12-04-2009, 03:30 PM
send me a pm with what kinda design you neeed, ill give ya a hand with this.
12-04-2009, 09:41 PM
i didnt forget about you haha, i just fell asleep... been sick past few days.. :(
12-04-2009, 10:48 PM
10.5x 38 (bottom) and 13.25 (Top) degree of cut should b e as close to 57.3 as possible 57.5 will work, or just mark both lengths on top and bottom and cut straight line from there.
left and right:
2.75x10.5 (bottom 2 inches is 12.1875 inches long) or as close as possible.
upper center wall:
11x9.5 with a roundover/45 cut on inner bottom of the wall.
lower center wall:
45 inside port is 1.65-1.7 on wider side.
bracing can be added optionally in the form of 2x4s 10.25 inches tall. centered on either side of the port.
really wish the design wasn't so specific on port size... :(