View Full Version : Headphone plug
11-19-2009, 02:10 AM
I have a pair of Sennheiser CX300s that I love. However, after listening to them heavily for a few months, the plug is bad and i only have sound out of the right side unless I wiggle the wire.
Anyhow, is there any way I could cut the plug off of these and off of like a $1 pair of walmart phones and solder them together? I don't have the $$ to get another nice pair of headphones.
11-19-2009, 02:18 AM
1/8" (3.5mm) for portable players from .76c up to $3.50-
1/4" for regular home stereos from .88c up to $5.15-
Look for the word "stereo" or two lines in the plug.
11-19-2009, 02:20 AM
well my worry is the wires inside. I've tried before and because of the material its made of, it just doesnt seem to work. should i treat it just like soldering any other wire?
11-19-2009, 02:24 AM
It has really thin wires?
You probably would need a low wattage iron.
You just may be better off splicing wires from another set in that case, especially for a temporary fix instead of the hassel of buying another iron.
11-19-2009, 02:26 AM
I think i'm going to hit up radio shack tomorrow and see what they've got.
11-19-2009, 02:27 AM
11-19-2009, 11:45 AM
Okay, ran to Radio Shack and picked up a plug. Cut the original plug off, and it left 4 wires exposed- one side is red and gold, and the other is green and red/green. Any idea as to the polarity of them? I've tried just twisting them around the leads on the plug with no avail.
11-19-2009, 12:22 PM
Only real way to figure out the polarity is to ohm out the connector you cut off to see which colors go where...