PDA

View Full Version : Enclosure 95% done, Check it out.



Pitchblack98
07-30-2009, 11:54 PM
Here is my box. I pretty much finished putting it together tonight. All I really need to do now is installed it and make sure it sounds good. Then I will take it back out and finish it with either carpet or aluminum diamond plate on the front and top.

It is going in an extended cab nissan frontierThe box is 4.2 cu.ft. tuned to 32hz. It will have 2 12" Type R's each running off of its own MRD-M1005.

I just need to figure out hows Im gonna run the wires to the amps. I have about an inch and a half between the last amp and the edge of the box. I may have to trim that edge off to have enough room to run the wires up the side of the box.

Tell me what you guys think.

http://i125.photobucket.com/albums/p62/Pitchblack98/Box/IMAG0017.jpg
http://i125.photobucket.com/albums/p62/Pitchblack98/Box/IMAG0018.jpg
http://i125.photobucket.com/albums/p62/Pitchblack98/Box/IMAG0020.jpg
http://i125.photobucket.com/albums/p62/Pitchblack98/Box/IMAG0019.jpg

da box king
07-30-2009, 11:59 PM
hope it does well with the port up

bhsdriller
07-31-2009, 12:00 AM
looks good man

LaserRed38
07-31-2009, 12:02 AM
Pretty neat. I used to have those amps. I thought they look better without the brushed covers on them. Maybe try it out?

Pitchblack98
07-31-2009, 12:03 AM
hope it does well with the port up

Only one way to find out... lol. Thats why Im not going to spend the time to finish it until I know how it sounds.


Pretty neat. I used to have those amps. I thought they look better without the brushed covers on them. Maybe try it out?

Thats why Im thinking about using some aluminum diamond plate for the top amp cover. I'm hoping it will match the silver covers, if not I may take your advice and pull them off to see how they look.

Twisted_0912
07-31-2009, 12:03 AM
box looks good

Pitchblack98
07-31-2009, 12:08 AM
It was also cut out on a CNC cutting table. Its nice not having to measure over and over again and setting up the table saw for different cuts. Just load up a cut list, throw a sheet of MDF on the table and then push the button. 10 minutes later you have a box ready to be put together. lol

LaserRed38
07-31-2009, 12:51 AM
Sounds good...

(Your plans for finishing the box hah)...

alexregalgs
07-31-2009, 12:52 AM
hope it does well with the port up

I was surprised at the loudness when i did a similar box for a pair of w3v3 12s and for some reason the frontier likes the port up