View Full Version : Is a Crunch 1400.4 too much for the ID or PPI comp sets?

07-09-2009, 05:53 PM
I have a kid that is looking for a good budget comp set, and has a Crunch Powerzone 1400.4. If it were to be bridged, would that be too much power for either the PPI set? Dont remember the mode number, but the ones that are coming up as a forum boner. Would the ID CTX65 do ok with the power?

Some people say they run crazy power and it takes it no problem, but just wondering if they would do ok this this amp, since I have no experience with these sets or how much power they will actually take.

This is the power rating, but its rated at max, and will probably do around 1/2 that, maybe a little less.

Power @ 4 Ohm: 700W x 2
Power @ 2 Ohm: 350W x 4
Power @ 4 Ohm: 175W x 4

07-09-2009, 06:01 PM
it's not really a matter of too much power but how he's using the power.

07-09-2009, 06:07 PM
I'm confused...why are you bridging it again?

07-09-2009, 08:23 PM
Define how you use it?

If you mean use it in a smiliar way to the way that people play their subs with 6krms each, then hell no. Screw that.

07-09-2009, 08:32 PM
how loud will he be turning the gain knob? what type of muisc? for how long of time?

07-09-2009, 08:36 PM
first wat exaclty is the full system? y do you want to bridge the amp to the comps?

07-09-2009, 09:00 PM
I think its 2 CVX 15s. I talked to him and I think he isnt going to bridge it. Pretty sure he wants to run the front 2 channels on the comps, then use the back 2 channels for 2 sets of coaxs in the rear deck.

07-09-2009, 09:01 PM
ok that'll be fine plenty of power for the ctx65cs mids. just make sure you send them a nice clean signal

James Bang
07-09-2009, 11:12 PM
first wat exaclty is the full system? y do you want to bridge the amp to the comps?

the answer is that he is from florida.

07-10-2009, 12:30 AM
the answer is that he is from florida.

Bridging an amp means youre from a certain state? :confused: