PDA

View Full Version : Component Set Impedance



Symphonic
05-13-2009, 03:40 PM
Hey I have 2 sets of PG RSD 65cs components.

According to sonic electronix the impedance is 4 ohms - but is this per speaker or what the crossover shows with both speakers connected?


So my question - 1 woofer + 1 tweeter through crossover shows ? ohms to amp?

4 ohms or 2 ohms?

thanks

pjhabit
05-13-2009, 03:45 PM
4 ohm

Symphonic
05-13-2009, 03:47 PM
Srsly?

Thanks.

I always thought it was showing my amp 2 ohms.

Symphonic
05-13-2009, 03:54 PM
Anyone confirm?

KyleBechtold
05-13-2009, 03:58 PM
its the final impedance load which is 4 in this case

KyleBechtold
05-13-2009, 04:00 PM
unless you are getting raw driver or tweeters comp sets will tell you the final load through the provided crossover.. some of them will also tell you the ohm load of each piece so if you were to go active you would know

nineball
05-13-2009, 04:35 PM
Anyone confirm?

confirm what? sonic told you 4ohms and someone else posted above this with the same response.

Virindok
05-14-2009, 08:46 AM
confirm what? sonic told you 4ohms and someone else posted above this with the same response.

I thought this set was 4 ohms per voice coil? So it would be 2 ohms?

Don't mean to confuse but that's what I read.