PDA

View Full Version : can you guys help??



MikeCole89
04-22-2009, 12:09 AM
can you help tell me if this sounds ok? box for two dc level 5s specs at bottom..this is the biggest dimensons i can go to fit it in my trunk
W:34 H:13 D:24=4.94 cubes..recommended for spl is 5.5

(port) H:11.75 W:3.25=38


Will i see a big differnce from 4.94 cubes instead of 5.5?? Also i am not sure what the internal volume would be after sub displacment


12"
Mounting Depth 8.25
Mounting Hole Diameter 11"
Motor Width 9.84"
Weight 78lbs
VC Diameter 3" Flat 8 layer
Magnet Weight 73lbs
Power Handling RMS/Peak 2000/4000 20,000 burst
Impedance D 1 or 2ohm
Sd 494.00 cm²
Suggested Ported 1.75³ ft
Suggested SPL Ported 2.75³ ft

PaulThompson229
04-22-2009, 12:10 AM
5 cubes will be fine for 2 12"s, I had my 12" in 2.4 cubes at 29Hz and she loved it.

MikeCole89
04-22-2009, 12:12 AM
ok well..im going to compete just wondering if i can loose a lot from that .5 cubes im loosing

PaulThompson229
04-22-2009, 12:17 AM
Not much I wouldn't think, and if your purely going for numbers you shouldn't be going by reccomended specs anyway, you would have to play with a few boxes and find out what works well with your car.

MikeCole89
04-22-2009, 12:22 AM
well i pretty much dont have room..im just going to go with subs firing foward port foward sealed from trunk.

oldschool4me
04-22-2009, 12:22 AM
Not much I wouldn't think, and if your purely going for numbers you shouldn't be going by reccomended specs anyway, you would have to play with a few boxes and find out what works well with your car.

i agree and also you would more than likely want smaller box- tuned high if your going pure spl.