View Full Version : Someone help design a box for 18" RD HW

04-05-2009, 06:25 PM
I have an RD Audio Heavyweight 18" that will be powered by either a RF T20001BD, or a crunch GP3000d, and i need a good box design... Its going in 1996 s10 blazer, so sub up port back is the goal, slot port along side, or bottom, either works...space im working with is 38wide,15tall, 33 deep... looking for tuning in the 36-40 range any ideas would be great...
thanks alot

-also, prolly a dumb question but is there a diff between the GP3000d and the GP3000d-pro? :confused:

04-05-2009, 06:31 PM
Mike465 on this forum does a lot of work for steve the owner of rd audio and knows the rd product inside and out and is a killer box builder you might want to contact him and get something worked out you will thank me later....

04-05-2009, 08:06 PM
your gonna want as close to 3kw as you can get. yeah i would pm mike465

04-05-2009, 08:07 PM
i have a design already drawn up that would work. 6cu.ft. tuned to 35hz i believe.

04-05-2009, 08:08 PM
Mike465 good box builder

04-05-2009, 08:15 PM
thegreatestpenn: any chance you could email me that design? It would help soooo much! [email protected] Thank you!

-Yea i figured 3000 would be a good load to put on this woofer... I have heard that with the right battery setup, that crunch will put mid 3k... that is if you keep it at 14v or so i believe..

04-05-2009, 08:43 PM
-also, prolly a dumb question but is there a diff between the GP3000d and the GP3000d-pro? :confused:

1500 watts, the Pro is RMS power, and the d is rated in max watts

04-08-2009, 04:35 PM
Anyone else??? I need a couple ideas to compare! any more help would be appreciated:)