PDA

View Full Version : Anyone bored enough to quickly 3d design?



JeepSound
04-02-2009, 01:08 AM
Finally ready to build the box for my single cab Ram.

It's a truck style box with a...

13.5" bottom depth
10" top depth
20" height
24.5" width
It'll be for (2) 12" Soundstream Rubicons with around a 7" mounting depth.
Tuned to somewhere in the 34hz range if possible.

Basically I'll need two of the above boxes sharing the same back board with a 16" gap in the middle used to hold the amp. So it'll end up looking like this, only less ******...

http://i17.photobucket.com/albums/b66/Legacy44/box.jpg

So if anyones bored, I could really use a 3D design with dimensions :)

thegreatestpenn
04-02-2009, 01:10 AM
google sketchup > you

Pioneer~Saturn
04-02-2009, 01:14 AM
That is a very small space...I wouldnt do it, unless that space is for each sub's enclosure..

JeepSound
04-02-2009, 01:18 AM
That is a very small space...I wouldnt do it, unless that space is for each sub's enclosure..

Came out to a little over 2 cubes each according to the calculator I used...
This is with 1/2" MDF as well so that'll make a slight difference.


EDIT: I think I see what you're getting at... The dimensions I listed will be the chamber for each sub, if thats what you're asking.

thegreatestpenn
04-02-2009, 01:19 AM
1/2" mdf is a no no

IDSkoT
04-02-2009, 01:21 AM
1/2" mdf is a no no

My .75 cubed box is made out of 1/2. I've had no problems.

Pioneer~Saturn
04-02-2009, 01:22 AM
Ok, that's better if those dimensions are for each sub..

JeepSound
04-02-2009, 01:22 AM
1/2" mdf is a no no

Should be adequate for what I'm using it for. Definitely not something to get loud with, these subs are SQ subs and will only be seeing around 300-400W each so I don't see it being a problem.

JeepSound
04-02-2009, 01:36 AM
ttt

JeepSound
04-02-2009, 02:11 AM
Up

JeepSound
04-02-2009, 02:12 AM
Double post. :crap: