PDA

View Full Version : buildin in trunk



BallinByNature
03-24-2009, 10:15 PM
how hard is it to build a box inside of the trunk??

peas247
03-24-2009, 10:18 PM
i didnt think it was too much fun. but i also did it by myself

BallinByNature
03-24-2009, 10:21 PM
how big was urs?

peas247
03-24-2009, 10:24 PM
dont remeber the full specs on the box, around 8 cubes before displacements.

jdmferio13
03-24-2009, 10:27 PM
dont remeber the full specs on the box, around 8 cubes before displacements.

8 cubes for 2 12's thats alotta of power with such a big box

BallinByNature
03-24-2009, 10:29 PM
i might do about 4 cubes my trunk opening is small

peas247
03-24-2009, 10:33 PM
8 cubes for 2 12's thats alotta of power with such a big box

naw, that was for when i had my 18" MT in there

bonesninja
03-24-2009, 10:34 PM
if it is not done in the right sequence...it can be down right impossible. Pocket holes for the screws can be a lifesaver in that situation. And be careful with the glue!!

BallinByNature
03-24-2009, 10:34 PM
how do u screw it and all that???

peas247
03-24-2009, 10:36 PM
how do u screw it and all that???

my build in trunk with the 18 was a temp box to see if i liked it. then if i did i was gonna pull it out and rebuild it nice. i liked it, but i tore everything out and sold it and said f*ck it. but thats me. ive seen it done and come out great.

bonesninja
03-24-2009, 10:51 PM
how do u screw it and all that???

pre-assembly outside the vehicle using only screws....pocket holes are preferred because they can drilled on the inside of the box. Assemble inside the car with glue and screws. Proper amount of screws i critical when you do it this way because the glue needs a very tight joint in order to hold properly

BallinByNature
03-24-2009, 10:56 PM
what r pocket holes?

bonesninja
03-24-2009, 10:57 PM
what r pocket holes?

google it:crazy:

BallinByNature
03-24-2009, 11:00 PM
oh ok i c now

fatpat1080
03-24-2009, 11:17 PM
a *****, glue and screws

peas247
03-24-2009, 11:51 PM
pre-assembly outside the vehicle using only screws....pocket holes are preferred because they can drilled on the inside of the box. Assemble inside the car with glue and screws. Proper amount of screws i critical when you do it this way because the glue needs a very tight joint in order to hold properly

yes very important. i had a side wall blow out on mine and a lot of leaks that took me forever to seal up