View Full Version : air bubbles
08-21-2003, 11:35 PM
I am building kickpanels for my Vifa PL mids, and while making the back molding I got some air bubbles. They aren't too bad though. I figured since it is only for kicks and not an actual sub box that it shouldnt be too bad, right? Well this was my first time using fiberglass, so I guess it was a good learning experience.
08-21-2003, 11:48 PM
Depends on how big they are, where they are, and how many layers you used...
08-21-2003, 11:54 PM
To answer your q's:
1) They aren't too big, just big enough to fit the 6.5's, since my car has the pedal type e-brake, not too much room.
2) They are right in the corners where kickpanels are typically made.
3) I only put 2 layers down so far, but I plan on putting a third, especially in the areas where it bubbled up.
So with this info, do you think it is ok that it bubbled up a little bit?
08-21-2003, 11:58 PM
In terms of how big they are/where they are, I was referring to the air bubbles, not the kicks themselves.
08-22-2003, 12:05 AM
Oh yeah, if you're at all worried about it, you can just put a sanding bit in your dremel, sand the air bubbles off, then glass over the area.........or you can start over. ;)
08-22-2003, 12:16 PM
Oh, well there about 2 air bubbles, but they are both about 1/4 long by 1/8 wide. One is near the top, about 1 1/2 from the top, and the other close to the center, but near the bottom more. I like the idea of sanding them off and putting another layer down on top. I was actually thinking of doing just that.