PDA

View Full Version : best way to run this setup....



jeepintn
01-28-2009, 06:13 PM
although i have had many setups over the years, i have never ran an active setup before and im debating whether or not with the equipment i have if it would be the best option for me. my equipment is as follows:

alpine cda-9835
ID CTX65cs comps, 100wrms 200 peak
eclipse pa-5422 4 ch amp (85x4 @ 4, 120 x 4 @ 2, 240x2@4 bridged)
2 sundown e8 subs
sub amp to be determined

jeepintn
01-29-2009, 12:52 AM
anyone?

jeepintn
01-29-2009, 12:29 PM
ttt

jeepintn
01-29-2009, 07:14 PM
up again, i know one of you audiophiles have a good suggestion

James Bang
01-29-2009, 08:21 PM
active.
tweets off HU
bridge mid to 4 channel
learn how to tune/decide for yourself.

jeepintn
01-29-2009, 08:50 PM
active.
tweets off HU
bridge mid to 4 channel
learn how to tune/decide for yourself.

so you are saying, run the tweets off the HU using the hu's processing xover and forget about the passive xover. then bridge each mid to essentially make the amp a 2 channel amp, giving each mid 240? tune through HU and good to go?

James Bang
01-29-2009, 08:58 PM
so you are saying, run the tweets off the HU using the hu's processing xover and forget about the passive xover. then bridge each mid to essentially make the amp a 2 channel amp, giving each mid 240? tune through HU and good to go?
i think so..



active.
tweets off HU
bridge mid to 4 channel
learn how to tune/decide for yourself.
keep gains low.