PDA

View Full Version : box question



xeroticsurfbumx
01-23-2009, 09:25 PM
im making a 4.3 cube box tuned to 35 hz , BUTTTTTTT
as i cut the boards some were 1/8th bigger or smaller the nteh desiered cut.
my question is if these 1/8th mistakes are on the outer frame area of the box
will it affect my box signifigantly? cause what happens is the sides kins of hang ocer the top and the bottom is a little wider but the inner dimensions are almost dead on. now i made a 1/8 too short of a cut on my port piece but im going to shim it 1/8 to make it normal size would this be okay?

pretty much my general question is im not dead on with my cutting but its pretty close is it going to destroy thebox/the sound it creates if i put it together correctly and sand out some of it?

xeroticsurfbumx
01-23-2009, 09:28 PM
32 hz port ***

pr-festiva
01-23-2009, 09:47 PM
as long as the box is solid and seald it will be ok,just wont be very pretty,,and you are not going to hear an 1/8th inch difference in the port.