Quality Box Manufacturer?

[mjlorenzo]

This isn't quite about box construction but this is my first sub install so I'm stickin w/ a pre-made enclosure. I need a solid sealed box for a 10" sub roughly .75 cu ft. I'll take recommendations for a manufacturer but if anyone has a particular box in mind, no need to raise your hand, just shout it out.

[bones22]

you would be far better off paying one of the guys here to build you one.

[jdawg]

ground shaker

[mlstrass]

Check out fishercustoms

[fasfocus00]

if you insist on going pre-made i'd go with pro-box.

[Mike465]

You got PM

[moo_awn]

you would be far better off paying one of the guys here to build you one.

If he wanted a ported enclosure, yes, but for a sealed a quality prefab will be fine. OP, check this out, probably your best bet. http://www.obcon.com/index.html?lmd=39062.312338

[moo_awn]

That link didn't go to where I thought it would. Click the link to R/T boxes at the top, then to the closeout tab on the left, then the single ten inch enclosure for $35.97.