PDA

View Full Version : single 10" downfiring home audio aero size?



budget76
12-12-2008, 02:58 AM
So, planning on tuning it around 30-32 hz, will be at 2.2 cubes before displacement, for a single 10, no more than 300 watts. Don't want to go lower, because I use it alot for music too.

Single 3" aero, single 4", or two 3"? It'll be downfiring. I'm planning on one 3" right now, will this be too little? Gonna be putting a lot of work into the box, don't want to fawk it up.

thanks guys

IDSkoT
12-12-2008, 03:00 AM
3" should be good for 300 watts. It won't be moving too much air, so you should be fine. Worse comes to worst, you take the aero out and drill a bigger hole. :P

thegreatestpenn
12-12-2008, 03:00 AM
4" with that size box, but 3" would suffice

tommyk90
12-12-2008, 03:03 AM
I use a single 4" for my single 10" home theater enclosure and it works just fine :)

IDSkoT
12-12-2008, 03:08 AM
I didn't see how big the enclosure was. I still say 3 will work, but I'd get 4.

budget76
12-12-2008, 01:26 PM
thanks guys. Appreciate it, 3" sounded a little small, but I Knew I wasn't going to be moving much air so I figured it might work.

One more question before I start a new thread on it. How high off the ground should the port be? II'm thinking like 2-3" will suffice, as I see the prefab ones way lower. Input?

budget76
12-12-2008, 08:46 PM
So I picked up the parts to do either a 3" or a 4", it'll just depend on what will fit in the box better I think. Build pics will maybe come, or at least the finished pics will be up by next week.