View Full Version : 3d box design

12-05-2008, 10:33 PM
can anyone do one for me? ported box for a Fi SSD 12.

john denver
12-06-2008, 05:21 PM
What dimensions do you have to work with or do you already have one planed out what tuning how many cubic feet you didnt give much info

john denver
12-06-2008, 10:43 PM

21W X 14H X 20D
2" port width 23" long
2.269 cubic feet 33.075hz

Top and bottom 21X20
left side 19.25X12.5
right side 18.5X12.5
back 21X12.5
front 18.25X12.5
port piece 1 16.5X12.5
port piece 2 2X12.5
Corner piece 1 11/16X12.5

12-06-2008, 11:27 PM
PERFECT! thanks a lot man! if you were gonna do a side or two in plexigass, which ones would you do?

12-06-2008, 11:30 PM
depends on which way its gonna be faceing in the car

12-06-2008, 11:37 PM
hm, prolly with the port to the back would be better right? opposite back seats? or no?

12-06-2008, 11:55 PM
yes is it in a trunk car, then i would do the back wall so that if you fold down the seats you can see threw the box

12-07-2008, 02:13 AM
well its actually gonna be in an Explorer. so if i faced it out, and did the plexi glass the side with the port, that would look pretty tight.