PDA

View Full Version : 1 amp or 2??



farmerehsan
12-05-2008, 12:06 PM
I bought all this stuff from anther person and this is how he had it set up...

he had the Jl audio TR050-CT Tweeters (NEW NEVER OPENED)

* Sensitivity: 91 dB
* RMS Power Range : 50 Watts
* Peak Power Handling: 125 Watts
* Frequency response: 4000-22000 Hz
* Diameter: 0.5 Inch

Features

* 0.50 in. / 12 mm textile dome diaphragm
* Integral phase plug
* Neodymium magnet
* Ferrofluid cooled and damped. 6dB / Octave inline filter included.
* Designed for flush or surface mounting.
* Continuous Power Handling: 50 Watts (with appropriate crossover)
* Peak Power Handling: 125 Watts (with appropriate crossover)


he said he had these are supposed to connect to the front speakers


he also had 2 6x9's and 2 5 1/4's running off of 1 JL AUDIO E2150 amp...thats a 2 channel... so every speaker is getting 75 watts?

now my question is i have a JL audio e1200 sitting around... can i use that on either 2 of the front or 2 of the rear and use thet other 2150 on the front? or rear?

what should i do? the spekaers are made my TMD??? i believe JL audio makes them also?

farmerehsan
12-05-2008, 12:27 PM
some help?

lyttleviet
12-05-2008, 03:26 PM
If they are both 4 channels, you can bridge the stronger amp to the front and put the weaker amp to the back.. I THINK that e1200 is a sub amp isn't it? Yeah I just looked it up. Its an A/B Mono. Don't use it on your highs, look for a small subwoofer that is either a single 4 ohm or dual 4 ohm sub and use the amp on that.

The way your friend ran the highs isn't good either... Basically you can't fade L/R?