PDA

View Full Version : KickPods



Untouchable6588
12-01-2008, 08:53 PM
Going to Start my little kick pod project had a few questions...I know how to fiberglass and I know how to make the kick pods just wondering one of the pods is going to be going over directly over my fuses is this going to be a problem any suggestions??There are already plastic kick panels there so i was thinking i should use that as my mold... Any other tips to make them sound the best beside the basics?

ramos
12-02-2008, 11:23 AM
Tape up the oem kicks. Then glass your floor molds with them in. Going over the fuse panel should be no problem. If you tape everything up first it will be easily removable after you make your floor molds. There are a bajillion different ways to make kicks though :)