$$15 For box plans

[edzy]

This is pretty much the set demensions.
Just need the port or ports worked out and a working set of prints (cutsheet)
If you need any more info, let me know.

http://i35.tinypic.com/9kb4p0.jpg

[bhsdriller]

pm mobeious, he does good work

[Rashaddd]

I got you, you want it in sketchup? and a cutsheet to go along with it? And that is a depth of 19.25" correct?

[adio]

go with rashadd........... see sig

[Rashaddd]

You've only got about 5.7 cubes total to work with after doubling sides and top, so after port displacement that will drop likely below 5 cubes, have you considered aero ports?

Drop me a pm man

Edit: You don't have the depth to do a port without have a 90 degree bend, so that makes aero's pretty inconvenient


go with rashadd........... see sig

:)

[edzy]

back at you.

[edzy]

this is pretty much the box, without sides extensions and x2 bafflle.
Just need the port added to the other side or a central port on the bottom. Again, want tuning to be ~30 and have minimun 60sq of port. would like to be as close to 5.5 cubes as possible. If need be I can go up about 2" on the height, but as minimul as possible. if say you add 1.5 on top, add .5 under . as well.

(if you double the port to 3.5 it tunes out at 30)

http://i33.tinypic.com/3499g8i.jpg

[Rashaddd]

There's just no way possible to get 5.5 cubes with that tuning and port area, most you can get is right about 4.3-4, minus driver displacement

[edzy]

bump.

[Rashaddd]

respond to my pm man

[edzy]

Thanks, nice plan.

http://i33.tinypic.com/b81hmf.jpg

[psych0ticnemes1]

Are you all set? If not, send me a PM and I'll help you out.