PDA

View Full Version : winisd help



er1kkull
06-26-2003, 08:02 PM
how many parameters do u actually need to make this work and will it show the design of the box? i got Qes Qms qts fs vas Xmax

er1kkull
06-26-2003, 09:35 PM
by entering all of them i get all of the calculations but the does graph does not seem to work it doesnt show any lines for front/rear port, passive radiator and driver but it does work on the system over all any suggestions?

Randy Savage
06-26-2003, 10:00 PM
Ignore any WinISD graph....they mean jack **** when you put something in a car...

ss3079
06-26-2003, 10:10 PM
BL, Cms, Sd, Mmd, Re, and Rms is all that you really need...I believe.

What sub are you trying to plug into WinISD? Most of us are able to give you specific box sizes and tuning's off the top of our heads that are proven time and time again to work well - though it depends on the vehicle, amount of power, etc...

- Steve

er1kkull
06-27-2003, 06:23 PM
12" aluminum cone (dvc) sw8122
vehicle = 02 extend cab S-10
Power = kx 800.2
thanks for the help so far

ss3079
06-27-2003, 06:40 PM
Get in touch with "denim" on these boards, also known as superfly47 on AIM ([email protected] I think)...he's a pro with Eclipse Alums;)

- Steve

er1kkull
06-27-2003, 06:42 PM
thanks

ss3079
06-27-2003, 06:49 PM
Originally posted by er1kkull
thanks

Also...denimsprofile on Yahoo! Messenger.

I know a guy with a 15" in a 1.4ft^3 sealed box, amazing SQ...but talk to denim and he'll be able to help.

- Steve