PDA

View Full Version : Port calculation help!



SPL KID
08-16-2008, 06:38 PM
Ok I came up with a enclosure design. I wanna check with you guys to see if it's correct.

In a 6 cube box I want (4) 6 inch ports it says 20.7 inches for vent lenght but i'm not sure if that is per port or a divided total can sombodies help please.

This is for 4 10's in a common chamber. Or suggest what you may please. need advice immediately.

gsuchyta
08-16-2008, 06:52 PM
Each 6" port needs to be 20.7" long for a tuning of 45hz.

gsuchyta
08-16-2008, 06:53 PM
it is not a divided total. So the total length of 6" port would be 82.8"

gsuchyta
08-16-2008, 06:54 PM
I'm guessing you are going for spl with that much port are for 4 10's and that high of tuning

SPL KID
08-16-2008, 06:58 PM
LOL did my S/N give that away?!?!?! :hilariou:

SPL KID
08-16-2008, 07:24 PM
ok 4 inches came out to be

4 diameter by 8.22 inches each

and i can seal off 2 ports to tune for street use. same with the 6 inchers.

which would be better?

SPL KID
08-16-2008, 09:18 PM
I went with the 4 4 inches after seeing the 6 inch ports! also takes up less box space!