PDA

View Full Version : need a box designer that can do a slanted box with round ports



fatboyracing
08-07-2008, 01:19 PM
Ok I am looking for someone how can do a design with an angle box with round ports if you can and are interested let me know.

this is for the dd9512g that I sold to a buddy of mine and know we are going to build a box.

it can be 34in wide and 12in tall the depth can vary but the 34x12 i would like to stay there

PSturmer
08-07-2008, 03:25 PM
any box designer can do this

KHARPS
08-07-2008, 03:27 PM
just mess around with this http://reaudio.com/speaker_box/LPort_Box_Calc.html
It gives you a cut sheet and everything

icweiner
08-07-2008, 08:17 PM
go to bcae1.com then go to number 110 which is the box calc

9seconlives
08-07-2008, 08:41 PM
Ok I am looking for someone how can do a design with an angle box with round ports if you can and are interested let me know.

this is for the dd9512g that I sold to a buddy of mine and know we are going to build a box.

it can be 34in wide and 12in tall the depth can vary but the 34x12 i would like to stay there


IF and ONLY IF all else fails...then check with this guy.......comes highly recommended by DD tech support.

http://pwkdesigns.com/

fatboyracing
08-07-2008, 08:53 PM
I need round ports I just assume to pay someone to do it right

schrummy
08-07-2008, 09:38 PM
i can do it for ya. what is the top and bottom max dims...

schrummy
08-07-2008, 09:39 PM
also where would you like the port to exit the box... on the side on the face or where.

schrummy
08-07-2008, 09:44 PM
srry for the triple post but....... how big of areo ports are you using. so i know how many to use...