View Full Version : wiring Honda Doors do I have to drill??

06-08-2003, 02:31 PM
Im putting 2 runs of 16 guage wire into my doors for components.

This is in a 1990 Honda civic.

Im thinking that the only way to get the wire in is to drill a hole in the door and a hole in the
body of the car, stick grommets in, and run the wires.

I really dont want to drill if i dont have to..

Anybody have any tips/experience installing components in Honda doors??

06-08-2003, 03:18 PM
i used the stock gromets..

06-08-2003, 04:56 PM
Nevermind. I just finished.
Way easier than I thought.

Cut the rubber boot that goes into the body-takes care of getting wires through car.

For the door, on a 90 civic theres no stock grommets. Took the door skin and plastic sheeting off,
shoved the drill inside the door. Eyed a spot just above the wiring plug. Drilled. Stuck grommet in.

Done deal.

06-08-2003, 05:03 PM