PDA

View Full Version : Here is my first "real" system



nittanylion64
06-26-2008, 07:38 PM
I have been on here for a little bit and have decided to show off my attempt at such a big system. Of course critiques are wanted.
First - The components
Alpine 9855
Clif Designs 6.5 Components - PX650C - Fronts
Clif Designs 5.25 Components - PX525C - Rears
CDT EF-8 8 inch subx2
Elemental Designs EU-700 6.5 Subx2
MB Quart RWE 302 12in Subx3
Powerbass ASA 400.4
Powerbass ASA 300.2
Powerbass ASA 1000.1
2 runs of Fosgate 4 gauge wiring
Vehicle is an 03 Explorer with the Big 3 done.

This is a lot of subs. The 2 elemental 6.5 subs will be fiberglassed into the front doors and will run all the time. The 8s will be fiberglassed into the rear floor and used when I have to take the 12s out and use the Explorer for Utility stuff. The 12s will be wired at 1.3ohm and the 8s will be at 2 ohm.

tc3k101
06-26-2008, 07:40 PM
are u running all those subs at the same time sorry a lil confused

nittanylion64
06-26-2008, 07:41 PM
The component sets. I had to make 5x7 adapters for the speaker openings. I also mounted the tweeters in the A-pillars. This was my first attempt at fiberglassing.

nittanylion64
06-26-2008, 07:47 PM
The Explorer ripped apart in the install. The sub box and amp locations. The four channel is under the drivers rear seat, the 2 channel is under the passenger rear seat and the sub amp is in the passenger rear wall.

nittanylion64
06-26-2008, 07:50 PM
are u running all those subs at the same time sorry a lil confused

I explained. Thanks, I forgot to explain it.

GMCJimmyslt2000
06-26-2008, 08:42 PM
ur gonna have some cancellation if u run the 8s and 12s at the same time