PDA

View Full Version : Angled Ports



Dafoo8kc
06-17-2008, 05:26 PM
Anyone familiar with using angled ports? I am building a small box with a 12" shallow mount sub and the port requirement is 4" by 12". The box is a wedge and is only 11" deep and 29" wide. So i was wondering if i can use a 4" 90 degree angle port and if this is ok where to mount it?

Or i have been told by so many different people that i could make the port work in many ways: like TWO 4" by 6" ports or TWO 2" by 12" ports. Anyone have any suggestions?:confused: