View Full Version : wiring tweeters questions

06-17-2008, 01:25 PM
Hey on a set of dd cx6.5 if I added another set of tweeters and wired them to the same loction that the tweets on the 6.5s will this damage anything. Also what will the ohm load going to my amp thank.

06-17-2008, 01:27 PM
good question tho cause i want to wire 4 sets of rsds to one xover to save space

u dont have a dmm to test ohm load??

06-17-2008, 01:38 PM
I have one but I have not order the tweets yet

06-17-2008, 09:10 PM
anyone else

06-17-2008, 11:07 PM
anyone I dont want to order these if I cant use them

06-18-2008, 05:00 AM
NO you can't just wire as many drivers on to one passive crossover as you want. The behavior of the crossover (filter point, slope, etc...) is dependant on the impedance wired to it. Change the impedance and you completely change the characteristics of the crossover.

James Bang
06-18-2008, 05:05 AM
the answer is to go active and wire as many tweets or mids your amp can handle, which I DON'T recommend. But if you have to do it, that would be the way.