PDA

View Full Version : question about glassing inside of box



orangecounty1
05-07-2008, 04:20 PM
when you glass the inside of a box (not just resin, im putting mat down as well)

do you just lay the mat, then resin over it and use like a roller or something so it goes down flat with no bubbles, etc? id assume that would be easier to put glass on a flat piece of wood, rather than a brush.

also, for the roof/sides, obviously the mat isnt just going to stick until u put the resin, so should i like spray adhesive the mat to the sides and top, then roll resin over that? or resin the wood, then while its still wet, stick the mat, then roll resin over that? would waste alot of resin, but i dont know, ive never done this.

any pointers?