View Full Version : Component Tweeter Door Install question.

04-12-2008, 11:25 PM
I'm planning on putting my component tweeters in the doors close to the woofer and need to drill the hole.. My question is the specified mounting diameter for these speakers is Tweeter Mounting Diameter (in): 1-13/32'', 36mm.. What size of hole saw should I be getting, should it be the same as the mounting diameter cause it's a weird number so I don't think I'm going to find one or should I get a 1 3/4 saw and then just trim?? I'm thinking at a 2" hole saw will be too big..

Thanks for any advice..

04-13-2008, 12:36 AM
A 1-3/4" hole saw will be too large.

A 1-3/8" hole saw will be 1/32" too small.

I'd give the 1-3/8" a try.