Imfinity Component wiring question

[All-or-Nothing]

I want to run 2 pairs of 2 ohms components in the front doors of my car. How would I wire each door using the crossovers. I will be running the same amount of speakers in the rear too. The comps are Infinity 6020CS (2 ohm) speakers with crossovers. My amp is the Infinity 7541 (4 channel).

2 mids and 2 tweets in each door.

[Trey803]

you only have 2 passive crossovers right?

[Trey803]

You could attempt running active with all four speakers on a separate channel of the amp. and not using the passive x-overs

[All-or-Nothing]

No I have 4 crossovers.

[Trey803]

do you have links to the equipment you have

[All-or-Nothing]

Speakers are 2 Ohm, 90 watts RMS, 270 watts Max..........Amp is 111 watts x 4 at 4 ohm. I got 4 sets of the speakers.

[All-or-Nothing]

Here is the Amp link.....http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?ProductID=18746

Here is the speaker link.....http://www.onlinecarstereo.com/CarAudio/ProductDetail.aspx?ProductID=18372

[Trey803]

just run each x-over on one of the channels of the amp

[All-or-Nothing]

just run each x-over on one of the channels of the amp


OK then would I just run the speakers in series off of the crossovers.

[All-or-Nothing]

Just realized I have 8 crossovers not 4