PDA

View Full Version : Re Calculator?



the727kid
03-26-2008, 08:01 PM
Is this thing legit? I tried it for shits and giggles and I come up with different numbers than this, and I even do the numbers that it says on the program to check it's self and it comes out wrong.

kickerlivinloud
03-26-2008, 08:07 PM
Lots of people seem to like it but, I've never found it to be accurate.

bones22
03-26-2008, 08:07 PM
been asked a lot

RE is slightly off but close

budahbuddy803
03-26-2008, 08:11 PM
i used it for my 2 mtx 7500s and i dont know if it was right, haha but it got loud and low as ****. I went with 4 cubes @ 38hz according to re.

tyler_fitz
03-26-2008, 08:12 PM
seems to do fine for most people, i dont think its off by too much... i built my box according to it and it sounds fine.

dcole18
03-26-2008, 09:44 PM
from what i have found its off in the port length part...

you just cant read the lengths for port length 1 and port length 2... they are always way short

the number you've gotta look at are the ones that say total port length, this length always seems to be spot on with the other calculators ive used

here:
http://i142.photobucket.com/albums/r95/dcole18/recalcisoff.jpg

casper97ta
03-26-2008, 11:02 PM
I use it and it seems to work good for basic boxes. I do the same thing Dcole is talking about, As long as the total port length is on point with what your going for it should be just fine.