PDA

View Full Version : 92 300zx setup



bobbjob22
04-24-2003, 04:38 PM
here is what i currently have:

HU- pioneeer 740mp

RTX02A Crossover
RTX02A Features
Two high pass and one low pass crossover points, continuously variable from 3Hz-400Hz
Selectable bass enhancement circuit (0dB or 12dB at 45Hz)
Three continuously adjustable output gain controls
12dB/octave slope
Signal to noise ratio >96dB and >.05% THD
Four gang potentiometers
DC to DC Power Supply

Thunder4202 2-Channel Amplifier
Specifications
Power 12.5 VDC Input
2 Ohm Load 100 w x 2 Low Level
4 Ohm Load 50 w x 2 Hi Level w/ Smart Engage
Bridged 4 Ohm Load 200 w Crossover(s)
Power 14.4 VDC Hi / Low @ 85Hz
2 Ohm Load 140 w x 2 Fixed, Defeatable
4 Ohm Load 85 w x 2 RCA Output
Bridged 4 Ohm Load 280 w Full Range Only
Dimensions
(with ISO Feet)
9.3" x 9.75" x 2.1"
23.6cm x 24.8cm x 5.3cm

Thunder4244 4-Channel Amplifier
Specifications
Power 12.5 VDC Input
2 Ohm Load 60 w x 4 Low Level, Input Select
4 Ohm Load 45 w x 4 Hi Level w/ Smart
Bridged 4 Ohm Load 120 w x 2 Crossover(s)
Power 14.4 VDC Hi / Low @ 85Hz -
Rear Fixed, Defeatable
2 Ohm Load 100 w x 4 Hi Pass @ 85Hz -
Front Fixed, Defeatable
4 Ohm Load 55 w x 4 RCA Output
Bridged 4 Ohm Load 200 w x 2 Full Range Only
Dimensions
(with ISO Feet)
11.5"x 9.75" x 2.1"
29.2cm x 24.8cm x 5.3cm
REAR
infinity kappa 42.5I
power Handling, RMS: 50 watts

Power Handling, Peak: 150 watts

Frequency Response (3dB): 75Hz - 21kHz

Sensitivity: 90dB

Impedance: 4 Ohms
FRONT
Pioneer TS-C160R
6-1/2'' aramid fiber composite cone woofer

1'' polyester-fiber soft-dome tweeter with magnetic fluid and neodymium magnet

Outboard crossover network included with -12 dB/octave HPF and -12 dB/octave LPF.

Tweeter level adjustment (0; -3 dB)

Nominal Power Handling: 60W

Max. Power 250W

Frequency Response: 25 Hz - 32 kHz

Sensitivity (Efficiency) (1W/1m): 90 dB

2-Channel amp POwers ONe sub
1 "12 sony sub
five-sided polypropylene cone

frequency response 18-2,000 Hz

power range 90-350 watts RMS

peak power handling 1200 watts

sensitivity 89 dB

Impedance 4 ohms

Dual Voice Coil No

Sensitivity 89dB

Frequency Response 18 - 2k Hz

RMS Power Range (Watts) 90-350

Peak Power Handling (Watts) 1200

i need to get a cap and i want to get a bigger amp because i am looking to get 2 R-type subwoofer 8" 10" or 12" i have little room any suuggestions on the amp and sub size. should i keep the crossover or run eveything throught the radio let me know what you clones think.



:p