PDA

View Full Version : Alpine X100 install



korndawg
02-21-2008, 05:25 AM
My X100 is due to arive on the 21st and am hoping to get it installed tonite. My car currently has the CDA-9835 in there now, so what are the chances that the x100 has the same alpine harness as the 9835 so i could just unplug the 9835 and plug it into the x100. Would sure make for a lightening fast install.

USCFAN
02-21-2008, 10:15 AM
http://www.caraudio.com/forum/showthread.php?t=282847

post a review!!!

Famous_78
02-21-2008, 10:20 AM
It more then likely will ive done it before but not with that model.

ProgMtl
02-21-2008, 11:33 AM
I'm betting it is different

Tonyguy
02-21-2008, 11:45 AM
I bet its different too being that the 9835 has the v-drive amp requiring power run to the battery. Tough luck.

LaserRed38
02-22-2008, 12:20 AM
Hmm....been thinking about this, but I still occasionally use CDs...

korndawg
02-22-2008, 12:31 AM
The connector was the same. I posted a little review on the unoffical post about this unit. Its sweet.

XXVANN
03-12-2008, 11:25 AM
Posted in the ida thread....

HawkiRod
09-17-2008, 03:28 PM
Hey guys, sounds like you know what you're doing when it comes to installing the X100. I'm going to be installing one of those puppies in my 1999 Honda Accord (I know, hot car right! lol) and just wondered if you knew of a wiring harness that would allow me to install the X100 plus the Bluetooth Adapter (KCE-300BT).

It would be IDEAL if there was a wiring harness that accomodated both, but I think I'm wishing for too much good karma...lol. I've been searching the internet but not having much luck so if you can steer me to the right harness I'd appreciate it!

XXVANN
09-23-2008, 03:13 PM
Hey guys, sounds like you know what you're doing when it comes to installing the X100. I'm going to be installing one of those puppies in my 1999 Honda Accord (I know, hot car right! lol) and just wondered if you knew of a wiring harness that would allow me to install the X100 plus the Bluetooth Adapter (KCE-300BT).

It would be IDEAL if there was a wiring harness that accomodated both, but I think I'm wishing for too much good karma...lol. I've been searching the internet but not having much luck so if you can steer me to the right harness I'd appreciate it!

A standard Metra wiring harness will connect your x100 to your factory stereo harness.

As for the bluetooth module, I have that as well and it comes with its own cable to connect into the back of the x100. It does not interface with the factory wiring harness at all.